Create a 60 × 60 × 60 mm cube.

1. Create a 60 × 60 × 60 mm cube. Create one of its diagonals as Axis from the Reference Geometry menu. Figure 2.29 shows the cube and the axis. Rotate a copy of the cube 30 degrees around the axis to get the result shown. 2. You need to verify and get the geometric information of the vertices, edges, and faces of the cube shown in Figure 2.29 A. Use SolidWorks to verify ONLY the top face of the cube, two of its edges, and its four vertices. Create the front face of the cube in the Front sketch plane such that the WCS origin is at the center of the front face (use a Center Rectangle on the Sketch tab). Extrude the sketch to the back, away from the viewing eye. Verify SolidWorks results manually. Do they match your hand calculations?


 

PLACE THIS ORDER OR A SIMILAR ORDER WITH brainy term papers TODAY AND GET AN AMAZING DISCOUNT

get-your-custom-paper

The post Create a 60 × 60 × 60 mm cube. appeared first on Cheapest Academic Custom Papers.

"Order a similar paper and get 15% discount on your first order with us
Use the following coupon
"FIRST15"

Order Now